Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
orion [2015/03/01 06:22] jthoel |
orion [2017/02/23 20:31] (current) John Benedetto ↷ Page moved from hardware:3dprinter:orion to orion |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== | ====== | ||
- | * This printer was so very graciousoly | + | {{: |
- | * [[http://seemecnc.com/products/orion-delta-3d-printer|Link | + | |
===== Details ===== | ===== Details ===== | ||
* 0.91 Firmware | * 0.91 Firmware | ||
Line 7: | Line 7: | ||
* 6" diameter (150mm - 75mm radius), 9" tall (220mm) | * 6" diameter (150mm - 75mm radius), 9" tall (220mm) | ||
* RAMBO controller, running Repetier | * RAMBO controller, running Repetier | ||
- | ===== Work path ====== | + | |
- | * Load STL into slice3r, choose the **PLA** filament and **Delta** printer, set your layer high, infill, support, etc -> export to gcode | + | ===== Preflight checklist |
- | * Copy gcode to microsd card (using mutliformat usb reader). | + | |
- | ===== Other Links ===== | + | There are no preflight considerations for this printer. |
+ | |||
+ | ===== Links ===== | ||
+ | |||
+ | * [[http:// | ||
+ | * [[http:// | ||
+ | |||
===== Log ===== | ===== Log ===== |