Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
room_sixteen [2019/01/27 20:31] John Benedetto |
room_sixteen [2023/03/27 14:33] (current) John Benedetto |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== 3D Printing Room ====== | ====== 3D Printing Room ====== | ||
- | < | + | <WRAP box> |
- | Josh Pedersen\\ | + | Tim Torres\\ |
3dprinting@quelab.net | 3dprinting@quelab.net | ||
<wrap caution> | <wrap caution> | ||
+ | Creality CR-10 Mini\\ | ||
Orion Delta Printer\\ | Orion Delta Printer\\ | ||
Prusa i3</ | Prusa i3</ | ||
- | This is our 3D printing | + | <WRAP round caution> |
+ | |||
+ | To help make 3D printing | ||
+ | |||
+ | ===== Makes and models ===== | ||
+ | |||
+ | * [[:prusa_mendel|Prusa Mendel]] | ||
+ | * [[:prusai3|Prusa ]] | ||
+ | * [[: | ||
+ | * [[: | ||
+ | * [[: | ||
+ | |||
+ | ===== Training & Problems ===== | ||
+ | |||
+ | <WRAP important round> Training is currently in flux. To be trained on the 3D printers, please contact the 3D printing officer via the [[http://pepper.quelab.net/mailman/listinfo/3d-printing|3d-printing mailing list]] to set up meeting on an open night. Without prior arrangement, | ||
+ | |||
+ | For information on usage, tips and 3D printing stuff, see: | ||
+ | |||
+ | * Using [[: | ||
+ | * A set of [[: | ||
+ | |||
+ | ===== Materials ===== | ||
+ | |||
+ | The table below specifies costs of materials kept at Quelab. | ||
+ | |||
+ | <WRAP info> All values are in //per-gram// increments of ALL consumed materials, **including** | ||
+ | |||
+ | ^Material^Members^Non-Members| | ||
+ | |ABS|$0.10|$0.20| | ||
+ | |PLA|$0.10|$0.20| | ||
+ | |NinjaFlex(([[: | ||
+ | |IGUS [[http:// | ||
+ | |||
+ | Materials must be cleared by a 3D printing officer. | ||
+ | |||
+ | Materials previously cleared for use in the 3D printers: | ||
+ | |||
+ | * Filamentium / FilamentOne PLA Extrafill | ||
+ | * Zen Toolworks ABS and PLA | ||
+ | * NinjaFlex | ||
+ | * IGUS Tribo filament | ||
+ | * Push Plastic ABS and PLA | ||
+ | * Taulman Nylon 230 | ||
[[room_map | Return to the building map]] | [[room_map | Return to the building map]] | ||