Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
prusai3 [2016/06/01 01:35] morgang ADD CONFIG FOR PRUSA i3 |
prusai3 [2023/03/27 14:31] (current) John Benedetto |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Prusa i3 printer ====== | ====== Prusa i3 printer ====== | ||
- | {{: | + | <WRAP center round info 60%> |
+ | **THIS CONTENT IS HISTORICAL**: | ||
+ | </ | ||
+ | |||
+ | |||
+ | {{: | ||
It's pretty fly. | It's pretty fly. | ||
Line 7: | Line 12: | ||
===== Parts & attribution ===== | ===== Parts & attribution ===== | ||
- | Most hardware was salvaged from the [[: | + | Most hardware was salvaged from the [[: |
Parts used (to some degree of knowledge): | Parts used (to some degree of knowledge): | ||
Line 21: | Line 26: | ||
* Stuff we had lying around | * Stuff we had lying around | ||
- | Parts were laser cut on OUR [[: | + | Parts were laser cut on OUR [[lasercutters|LASER CUTTER]] from SCRAP! And it looks pretty good all things considered. |
===== Preflight checklist ===== | ===== Preflight checklist ===== |