Area Captain
Tim Torres
3dprinting@quelab.net
YELLOW TOOLS
Creality CR-10 Mini
Orion Delta Printer
Prusa i3
The 3D Printers are YELLOW tools, and require additional training
To help make 3D printing at quelab awesome-er, sign up for the 3d-printing mailing list. It's low-volume, but high-quality.
Training is currently in flux. To be trained on the 3D printers, please contact the 3D printing officer via the 3d-printing mailing list to set up meeting on an open night. Without prior arrangement, there is no guarantee that there will be a 3D printing trainer available during an open night, however.
For information on usage, tips and 3D printing stuff, see:
The table below specifies costs of materials kept at Quelab.
All values are in per-gram increments of ALL consumed materials, including failed prints and support material.
| Material | Members | Non-Members |
|---|---|---|
| ABS | $0.10 | $0.20 |
| PLA | $0.10 | $0.20 |
| NinjaFlex1) | TBD: Likely in the $0.60/g range | |
| IGUS Tribo | Go get a sample from IGUS. It's expensive. | |
Materials must be cleared by a 3D printing officer.
Materials previously cleared for use in the 3D printers: