Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
prusai3 [2016/06/01 01:35]
morgang ADD CONFIG FOR PRUSA i3 		prusai3 [2023/03/27 14:31] (current)
John Benedetto
Line 1: Line 1:
 ====== Prusa i3 printer ====== ====== Prusa i3 printer ======
  
-{{:hardware:3dprinter:printer_prusai3.jpg?100  }}The Prusa i3 is a [[:hardware:3dprinter:start|3D printer]] at Quelab. It was built when the [[:hardware:3dprinter:prusa_mendel|Prusa Mendel]] caught fire; Ben K and Morgan G worked through a long night to get the carcass of the old printer disassembled and a new shell made.+<WRAP center round info 60%> 
 +**THIS CONTENT IS HISTORICAL**: This printer was decommissioned, and this information is historical in nature. It has been superseded by the [[:blinky|Troybot, an i3v from MakerFarm]].  
 +</WRAP> 
 + 
 + 
 +{{:hardware:3dprinter:printer_prusai3.jpg?100  }}The Prusa i3 is a [[:room_sixteen|3D printer]] at Quelab. It was built when the [[:prusa_mendel|Prusa Mendel]] caught fire; Ben K and Morgan G worked through a long night to get the carcass of the old printer disassembled and a new shell made.
  
 It's pretty fly. It's pretty fly.
Line 7: Line 12:
 ===== Parts & attribution ===== ===== Parts & attribution =====
  
-Most hardware was salvaged from the [[:hardware:3dprinter:prusa_mendel|Prusa Mendel]] printer. Only a few parts have been purchased or scavenged from outside sources.+Most hardware was salvaged from the [[:prusa_mendel|Prusa Mendel]] printer. Only a few parts have been purchased or scavenged from outside sources.
  
 Parts used (to some degree of knowledge): Parts used (to some degree of knowledge):
Line 21: Line 26:
     * Stuff we had lying around     * Stuff we had lying around
  
-Parts were laser cut on OUR [[:lasercutter|LASER CUTTER]] from SCRAP! And it looks pretty good all things considered.+Parts were laser cut on OUR [[lasercutters|LASER CUTTER]] from SCRAP! And it looks pretty good all things considered.
  
 ===== Preflight checklist ===== ===== Preflight checklist =====