Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
hardware:lasercutter:start [2016/05/29 23:52] morgang Stub usage link |
hardware:lasercutter:start [2016/05/29 23:52] (current) morgang oops |
||
|---|---|---|---|
| Line 36: | Line 36: | ||
| ^ Plywood | YES | untreated ONLY! | | ^ Plywood | YES | untreated ONLY! | | ||
| ^ Polyacrylate | YES | Lots of ventilation is needed. Give 20-30 seconds after cut completion to open hood. | | ^ Polyacrylate | YES | Lots of ventilation is needed. Give 20-30 seconds after cut completion to open hood. | | ||
| - | ^ Aluminum | YES | **Engrave only**: Low power engraving is possible. | + | ^ Aluminum | YES | **Engrave only**: Low power engraving is possible. |