Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
hardware:lasercutter:start [2016/05/29 23:51] morgang ↷ Page moved and renamed from hardware:lasercutter to hardware:lasercutter:start |
hardware:lasercutter:start [2016/05/29 23:52] (current) morgang oops |
||
|---|---|---|---|
| Line 14: | Line 14: | ||
| ===== Basic usage ===== | ===== Basic usage ===== | ||
| - | See also: XXX | + | See also: [[usage|Using LaserCut]] |
| - Load DXF into LaserCut | - Load DXF into LaserCut | ||
| Line 36: | Line 36: | ||
| ^ Plywood | YES | untreated ONLY! | | ^ Plywood | YES | untreated ONLY! | | ||
| ^ Polyacrylate | YES | Lots of ventilation is needed. Give 20-30 seconds after cut completion to open hood. | | ^ Polyacrylate | YES | Lots of ventilation is needed. Give 20-30 seconds after cut completion to open hood. | | ||
| - | ^ Aluminum | YES | **Engrave only**: Low power engraving is possible. | + | ^ Aluminum | YES | **Engrave only**: Low power engraving is possible. |