Differences
This shows you the differences between two versions of the page.
|
blinky [2017/12/20 20:54] morgang created |
blinky [2017/12/21 22:40] (current) morgang |
||
|---|---|---|---|
| Line 6: | Line 6: | ||
| * E3D v6Lite hotend (someday clone e3dv6) | * E3D v6Lite hotend (someday clone e3dv6) | ||
| + | It is configured for OctoPrint running on a Raspberry Pi. Details later. | ||
| + | ===== Basic maintenance and preflight ===== | ||
| + | |||
| + | The fan on the extruder should kick on at 50C. If it does not, touch the fan and give it a gentle spin widdershins (anticlockwise). | ||