Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
3dprinters [2016/05/29 12:43]
John Benedetto [Training & Problems] 		— (current)
Line 1: Line 1:
-====== 3D Printing ====== 
- 
-<WRAP round caution>The 3D Printers are [[:training|YELLOW tools]], and require additional training</WRAP> 
- 
-To help make 3D printing at quelab awesome-er, sign up for the [[http://pepper.quelab.net/mailman/listinfo/3d-printing|3d-printing mailing list]]. It's low-volume, but high-quality. 
- 
-===== Makes and models ===== 
- 
-    * [[hardware:3dprinter:prusa_mendel|Prusa Mendel]] 
-    * [[:hardware:3dprinter:prusai3|Prusa i3]] 
-    * [[:hardware:3dprinter:orion|SeeMeCNC ORION Delta Printer]] 
-    * [[:printirnator|Printirnator]] 
-    * [[:makerbot|Makerbot Cupcake / Thing-o-Matic]] 
- 
-===== Training & Problems ===== 
- 
-To get trained to use Quelab's 3D Printers, sign up for the [[http://pepper.quelab.net/mailman/listinfo/3d-printing|3d-printing mailing list]], then send a request, asking for training.  There is often a traning-qualified member attending HackNight((Hacknight is Quelab’s version of an active open house. We encourage our members to show up to work on projects, be social, and at the same time invite interested persons of the community to come on down and check it out. This also allows non-members to try out the space and to start making, as well as meet current members. Hacknights are also a great time to take a tour, get policy orientation, as well as some group training.)), but without prior agreement there is no guarantee someone will be there. 
- 
-For information on troubleshooting, please refer to the [[:hardware:3dprinter:troubleshooting|print troubleshooting]] page for how to figure out what's going wrong. 
- 
-===== Materials ===== 
- 
-Different 3D printers accept different materials. Check the page for [[hardware:3dprinter#makes_and_models|whichever printer you are using]] to identify allowable filament. 
- 
-The table below specifies costs of materials kept at Quelab. 
- 
-<WRAP info> All values are in //per-gram//  increments of ALL consumed materials, **including** failed prints and support material.</WRAP> 
- 
-^Material ^Members ^Non-Members | 
-|ABS |$0.10 |$0.20 | 
-|PLA |$0.10 |$0.20 | 
-|NinjaFlex(([[hardware:3dprinter:prusai3|Prusa i3]] only))  |TBD: Likely in the $0.60/g range || 
-|IGUS [[http://www.igus.com/wpck/15422/iglidur_TriboFilament|Tribo]] |Go get a sample from IGUS. It's expensive. || 
- 
-Materials must be cleared by a 3D printing officer. 
- 
-Materials previously cleared for use in the 3D printers: 
- 
-  * Filamentium / FilamentOne PLA Extrafill 
-  * Zen Toolworks ABS and PLA 
-  * NinjaFlex 
-  * IGUS Tribo filament 
- 
-Any material that is in the 3D printing room is considered cleared if it is on the rack above the 3D printers. 
- 
-